Replacement Part List

20 | Westinghouse Portable Power

MANUALLY STARTING A GENERATOR

NOTE: This procedure can also be used on an

electric start generator.

1. Check oil levels (see Adding Engine Oil page 24)

2. Make sure the circuit breakers are properly set (see

Figure 13 below).

240/120VMain Circuit Breaker Operating Position

240/120V Main Circuit Breaker Tripped Position

120V Circuit Breaker Operating Position

120V Circuit Breaker Tripped Position

2. Move the fuel shut o valve to the ON position (see

Figure 14 below).

Figure 14 - Fuel Shut O - ON

3. Move the choke lever to the ON position

(see Figure 15 below).

Figure 15 - Choke - ON

4. Push the engine control switch into the RUN

position (see Figure 16 below).

5. Firmly grasp and pull the recoil handle slowly until

you feel increased resistance. At this point, apply

a rapid pull while pulling up and slightly away from

the generator (see Figure20).

6. As the engine starts and stabilizes, gradually move

the choke lever back to the OFF position. (Figure 18)

Figure 18 - Choke - OFF

OPERATION

Figure 13 - Breakers

Figure 16 - Engine Control Switch - RUN

Figure 17 - Engine Recoil Handle - PULL