Installation Guide

9
ASSEMBLY INSTRUCTIONS
Hardware Used
GG
KK
10. Support heater. Slide three washers washer Φ8 (GG)
over threaded end of spacer. Locate reflector assembly
on 3 spacers. Install three washers Φ8 on spacers and
securely tighten wing nuts (KK) but do not overtighten.
x 6
Washer Φ8
x 3
Wing nut
10
KK
GG
11
11. Connect hose and regulator to cylinder.
The propane gas and cylinder are sold separately.
Use a standard 20 lb. propane cylinder only
(approximately 12.2 in. / 31cm. in diameter and 17.9 in.
/ 45.5cm high).
Use this heater only with a propane vapor withdrawal
supply system. See chapter 5 of the standard for
storage and handling of liquefied petroleum gas,
ANS/NFPA 58. Your local library or fire department
should have this book.
Storage of an appliance indoors is permissible only if
the cylinder is disconnected and removed from the
appliance. A cylinder must be stored outdoors in a
well-ventilated area out of the reach of children.
A disconnected cylinder must have dust caps tightly
installed and must not be stored in a building, garage or
any other enclosed area. The maximum inlet gas supply
pressure: 250 psi /1750 kPa. The minimum inlet gas
supply pressure: 5 psi /35kPa. Manifold pressure with
regulator provided: 11 inch W.C/ 2.74 kPa. The minimum
hourly of 17000 Btu /4.98 kW is required input rating for
an appliance for automatic operation at ratings less than
full input rating. The pressure regulator and hose
assembly supplied with the appliance must be used.
The installation must conform with local codes, or in
the absence of local codes, with national fuel gas code,
ANS Z223.1/NFPA54, natural gas and propane Installation
Code, CSA B149.1, or propane storage and handling
code, B149.2.
Standard 20 lb. tank
12.2 in. / 31cm
17.9 in. / 45.5cm