Installation Guide

ASSEMBLY INSTRUCTIONS

4. Load Cylinder Housing onto Post.

Slide Cylinder Housing down.

5.Attach reflector spacers (FF) and three washers Ø8

(GG) to screen cover. Tighten the reflector spacers.

Unscrew four stainless steel bolts (DD).

6. Load head assembly by inserting hose into post.

Insert head assembly into post.

Attach head assembly to post, and loosely install four

stainless steel bolts. Tighten bolts securely.

Note: The control knob on head assembly should

be above the decal on post. When applicable,

visually checking portions of the hose assembly

located within the confines of the heater post.

x 3

Reflector Spacer

x 3

Washer Φ8

Hardware Used