Specifications

6. Gently place the burner trim piece around the
burner (see Figure 77). It sits on various support
brackets and ts around the burner tray and up
against the rebox liner. Figure 78 shows the burner
trim in the correct position. Ensure a minimum ⅜”
(8mm) gap is maintained around the burner glass
tray (see Figure 79).
7. If the optional rock accent kit was purchased for
the DV62, you can place the rocks in a random
pattern around the glass tray. A few can straddle
the 1/2” (13mm) gap around the glass tray. Try to
keep them looking randomly placed. Keep from
placing them in large piles as they need to be evenly
distributed. Examples are shown in Figure 80.
It is important that rock accents are not placed
in front or over the pilot assembly. This may
prevent the burner from lighting in a timely
fashion or overheat the pilot assembly. Keep an
area of about 3” (75mm) in front of the pilot
light free from obstruction and rock accents (see
Figure 81).
Figure 76: Glass Tray with Mixed Glass.
Figure 77: Burner Trim Being Placed.
inStallation Set-uP
Figure 81: Keep Area in Front of Pilot
Assembly Clear.
Figure 78: Burner Trim in Correct Position.
Figure 79: Proper Gap Between The Glass Tray and
The Burner Trim
Pilot Assembly
Keep this
area clear.
Figure 80: Rock Accents
40