Specifications

Figure 72: Mixing Tubes in Glass Burner.

Figure 73: Placing Glass Burner.

1. In the bottom rear of the rebox there are two (2)

gas orices in a housing that facilitate the air shutter

mechanisms and the Burner Mounting Brackets are above

them (See Figure 71). There are two (2) mixing tubes

underneath the back of the burner (see Figure 72). Lift the

burner into the rebox with the back of the burner tilted

downward. Keep the burner high enough at the front to

clear the pilot assembly. Line up the mixing tubes with the

holes in the burner mounting brackets and slowly lower the

front of the burner over the pilot assembly (see Figure 73).

2. Pull the burner forward up to the angular brackets near the

front of the rebox (see Figure 75). The burner rests on

the oor of the rebox and is properly aligned against the

two (2) front burner rests.

IMPORTANT: If the burner is not far enough back to lower

the burner behind these brackets, then the mixing tubes are

not engaged in the air shutter. Failing to ensure the mixing

tubes are located in the mixing tube support brackets may

cause serious performance and or safety issues.

3. Place the glass tray over top of the burner top as shown in

Figure 74. It simply rests over the top section of the burner.

4. In front of the pilot assembly, on the front edge of the

burner is one burner port which helps in the lighting of the

main burner (see Figure 75). The glass tray has one

hole in the same position that allows the gas to ow

to this location. Ensure the glass tray hole is properly

positioned over the port in the burner.

5. The DV62 glass burner option is supplied with two (2)

quantities of glass, black and white. There is enough

of either to ll the burner, so you can decide whether

to install all white, all black, or some type of mixture.

Place crushd glass evenly in the burner tray and ll

glass to the top untuil they are level with the 4 sides of

the tray (example in Figure 76). Try to keep glass from

falling in around the pilot assembly.

inStallation Set-uP

gLass buRneR instaLLation:

Figure 75: Glass Burner in Place Figure 74: Glass Tray over Burner

Figure 71: Burner Mounting Brackets