Specifications

inStallation Set-uP
eLectRicaL hook-up:
An electrical junction box is provided and fastened to the back of
the control box. Power needs to be brought to the electrical junction
box. The power for the various control components are all provided
from the fan control module. Remove the control box cover, install the
provided electric outlet and cover and plug the fan control module into
it. See the Rating Label for the listed electrical requirements.
When installed, the DV62, must be electrically grounded in accordance
with local codes or, in the absence of local codes, with the National
Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA
C22.1.
WARNING
Electrical Grounding Instructions
This appliance is equipped with a three-prong (grounding) plug
for your protection against shock hazard and should be plugged
directly into a properly grounded three-prong receptacle. Do not
cut or remove the grounding prong from this plug.
Figure 46: Location of Electrical Hook-Up.
FiRebox LineR instaLLation:
IMPORTANT: Complete the installation of ue restrictor before proceed the rebox liner installation. The paint
on the panels may fade for the rst 8-10 hours of burn time, but will come back to its color after the paint has
cured. The paint is very delicate and handling them with care is necessary not to mark or smudge the paint.
Figure 47: Rear Firebox Liner Panel In Place
1) Install the Rear Firebox Liner Panel. This panel rest on top of the rear brick panel support. Hold it with
one hand or have someone else hold it while place in the Left Panel.
2) Install the Left Firebox Liner Panel; it sits on the bottom front edge of the rebox (see Figure 48), a support
bracket at the lower rear of the rebox, and is held in by a retainer at the top of the rebox. Adjust the
panel retainers as required.
3) Install the Top Firebox Liner Panel by placing it on top of the Rear Panel and behind the Left Panel (see
Figure 50 and 51). Hold it with one hand or have someone else hold it for you while you place the last
panel. WARNING: If this panel falls from this location it will possibly break or the paint work will become
chipped.
4) Install the Right Firebox Liner Panel in the same manner used for the Left Panel (see Figure 52). The
vertical edges of the left and right panels should line up with the front edges of the rebox sides.
Figure 48: Left Firebox Liner Panel on Front Edge
30