NODE Instructions for Use 0000000033 NODE V6 INSTRUCTIONS FOR USE Document Number: 0000000034 Date: 1st July 2020 Revision: A.2 Copyright © 2020 STRYDE. All rights reserved.
Node Instructions for Use Copyright © 2020 STRYDE. All rights reserved. INTELLECTUAL PROPERTY No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual, or otherwise, without prior written permission of STRYDE. Copyright violators also may be subject to civil penalties.
NODE Instructions for Use Table of Contents 1. Safety Information ____________________________________________________ 2 2. Certifications _________________________________________________________ 2 3. Introduction __________________________________________________________ 2 4. Product Overview _____________________________________________________ 3 5. Technical Specifications ________________________________________________ 3 6.
Node Instructions for Use 1. Safety Information The following general safety precautions must be observed during all phases of operation of this product. WARNING Do not use the device if it appears damaged or defective. Do not dismantle or try to repair a broken unit. Do not perform any unauthorized modification or change to the device. Do not expose to excessive heat or flames. CAUTION Dropping the device and other mechanical abuse may cause damage to sensor, electronics and mechanical parts.
Node Instructions for Use 4. Product Overview The STRYDE Node is an entirely sealed, self-contained nodal recording sensor. The unit uses wireless data transmission through an optical link and wireless battery charging through an inductive coil. The optical transmitter is low-energy and considered not hazardous to people nor animals. The battery is a single Li-Ion cell, and charging is done by system specific battery chargers.
Node Instructions for Use Bespoke magazines and backpacks are used for lifting and carrying the Node in the field. In the hub, there are jib cranes available that should be used for lifting and moving trays of Nodes. The Node shall be inspected for damage when retrieved from the field. Units with broken housing shall be clearly marked on the top cap so they are easily identified when placed in a magazine.
Node Instructions for Use 10. End of Life This product shall be safely disposed of as electronic waste. The owner of the system is responsible for disposal in accordance with local laws and regulations at the time it is disposed of. The unit contains recyclable materials and they should be recycled where facilities are available. Ultimate disposal of this product should be handled according to all national laws and official regulations.
Node Instructions for Use 13. Compliance Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
