User`s guide

17-6
Command Reference Guide
/J Display Site ID / Unit Information
Displays the user-defined Site I.D. message. If the optional asterisk (*) argument is
included in the command line, the command will also show model number, serial
number, current rating and software version for the VMR/NPS unit.
Availability: Administrator, SuperUser, User, ViewOnly
Format: /J [*] [Enter]
Where * (asterisk) is an optional command argument, that is used to display the
model number, current rating and software version for the VMR/NPS unit.
17.3.2. Control Commands
/X Exit Command Mode
Exits command mode. When issued at the Network Port, also ends the Telnet session.
Note: If the /X command is invoked from within a configuration menu, recently
defined parameters may not be saved. In order to make certain that parameters
are saved, always press the [Esc] key to exit from all configuration menus and
then wait until "Saving Configuration" message has been displayed and the
cursor has returned to the command prompt before issuing the /X command.
Availability: Administrator, SuperUser, User, ViewOnly
Format: /X [Enter]
/C Connect to Serial Port
When the RJ-45 SetUp Port has been configured as a Normal Mode Port as described in
Section 5.8, the /C command can be used to create a connection between the Network
port and the serial SetUp Port.
Notes:
• User level accounts can only connect to the SetUp Port when serial port
access is specifically permitted by the account.
• To terminate a port connection, either type ^X ([Ctrl] plus [X]) or invoke the
currently defined disconnect sequence.
Availability: Administrator, SuperUser, User
Format: /C 1 [Enter]