User`s guide

5-42
Basic Configuration
5.9.2. Network Parameters
In the Text Interface, these parameters are accessed via the main Network Configuration
menu, which can be activated by typing /N (for IPv4 parameters) or /N6 (for IPv6
parameters) and then pressing [Enter]. In the Web Browser Interface, these parameters
are found by placing the cursor over the "Network Configuration" link on the left hand
side of the screen, and then clicking on the "Network Parameters" link in the resulting
fly-out menu.
Note:TheIPAddress,SubnetMask,GatewayAddressandDHCPstatus
cannotbechangedviatheWebBrowserInterface.Inordertochangethese
parameters,youmustaccesstheTSM/RSMviatheTextInterface.
• IPAddress: (Defaults: IPv4 = 192.168.168.168; IPv6= undefined)
• SubnetMask: (Defaults: IPv4 = 255.255.255.0; IPv6 = undefined)
• GatewayAddress: (Default = undefined.)
• DHCP: Enables/Disables Dynamic Host Configuration Protocol. When this option
is "On", the TSM/RSM will perform a DHCP request. Note that in the Text Interface,
the MAC address for the TSM/RSM is listed on the Network Status Screen.
(Default = Off.)
Note:BeforeconfiguringthisfeatureviaTelnetorWeb,makecertainyour
DHCPserverissetuptoassignaknown,fixedIPaddress.Youwillneedthis
newIPaddressinordertoreestablishanetworkconnectionwiththeTSM/RSM.
• TelnetAccess: Enables/disables Telnet access. When Telnet Access is "Off," users
will not be allowed to establish a Telnet connection to the unit or initiate outbound
Telnet or SSH connections. (Default = On.)
• TelnetPort: Selects the TCP/IP port number that will be used for Telnet
connections. (Default = 23.)
Note:IntheTextInterface,thisitemisdefinedviaasubmenu,whichis
displayedwhentheTelnetAccessparameterisselected.
• Max.PerSource(PerSource): The maximum number of Telnet sessions that will
be allowed per user MAC address. (Default = 4.)
Notes:
• IntheTextInterface,the"Max.PerSource"(PerSource)parameterisdefined
viaasubmenuofitem21(TelnetAccess)intheNetworkParametersmenu.
• Afterchangingthe"MaxPerSource"parameter,youmustlogoutofallpre-
existingTelnetsessionsinorderforthenewmaximumvaluetobeapplied.
• SSHAccess: Enables/disables SSH communication. (Default = On.)
• SSHPort: Selects the TCP/IP port number that will be used for SSH connections.
Note that in the Text Interface, this item is defined via a submenu, which is
displayed when the SSH Access parameter is selected (item number 22.)
(Default = 22.)