User`s guide

2-11
Unit Description

NetworkPort: An RJ45 Ethernet port for connection to your 10Base-T or
100Base-T, TCP/IP network. Note that the RSM-8R4-DCM features a default, IPv4
format IP address (192.168.168.168). This allows you to connect to the unit without
first assigning an IP address. The Network Port also includes two LED indicators
for Link and Data Activity. For more information on port configuration, please refer
to Section 5.9.

InternalModemPort: For connection to your external phone line. For more
information on Modem Port configuration, please refer to Section 5.8.

DCDIndicator: The Data Carrier Detect indicator.

PowerInlet: An IEC320-C14 AC inlet which supplies power to the RSM-8R4-DCM's
control functions and switched power outlets. Also includes cable keeper
(not shown.)

SwitchedOutlets: Four AC Outlets that can be switched On, Off or rebooted in
response to user commands:
• RSM-8R4-1: Four (4) each, NEMA 5-15R Outlets.
• RSM-8R4-2: Four (4) each, IEC320-C13 Outlets.
2.10. Front Panel Button Functions
The front panel buttons can be used to perform several functions described below:
Notes:
• FrontPanelbuttonfunctionscanalsobedisabledviatheSystemParameters
menu,asdescribedinSection5.3.
• WhentheTSM/RSMisresettofactorydefaults,alluser-definedconfiguration
parameterswillbeclearedandthedefault“super”useraccountwillalsobe
restored.
• WhentheTSM/RSMisreinitialized,allportswillbedisconnected.
• Duringtherebootprocedure,allportactivityLEDswillflashonce.
1. RebootOperatingSystem-KeepUser-DefinedParameters:
a) Press and hold the CLEAR (or RESET) button for five seconds, and then
release.
b) The TSM/RSM operating system will reboot; all user-defined parameters will be
retained.
2. RebootOperatingSystem-ResetAllParameterstoFactoryDefaults:
a) Simultaneously press both the SET (or DEFAULT) button and the CLEAR (or
RESET) button, hold them for five seconds, and then release.
b) The TSM/RSM operating system will reboot; all user-defined parameters will be
reset to factory default settings.
Note:TheRDYIndicatorwillcontinuetoblinkforabout45secondswhile
parametersarebeingerasedandkeysarerebuilt.TheRDYIndicatorwillthen
stopblinkingduringthereboot.