User`s guide

5-20
Basic Configuration
• PortAccess: Determines whether or not the account will be allowed to connect to
the serial Console Port. (Defaults; Administrator and SuperUser = Always Enabled,
User = Disabled.)
Note: ViewOnly level accounts cannot be granted access to the Console Port.
• CircuitAccess: Determines which circuit(s) this account will be allowed to control.
(Defaults; Administrator and SuperUser = All Circuits On, User = All Circuits Off,
ViewOnly = All Circuits Off.)
Notes:
• Administrator and SuperUser level accounts always have access to all
circuits.
• User level accounts will only have access to the circuits that are defined via
the "Circuit Access" parameter.
• ViewOnly accounts are allowed to display the Circuit Status Screen, but are
limited to the circuits specified by the account. ViewOnly accounts are not
allowed to invoke switching and reboot commands.
• CircuitGroupAccess: Determines which circuit groups this account will be
allowed to control. For more information on Circuit Groups, please refer to
Section 5.6. (Defaults; Administrator and SuperUser = All Circuit Groups On,
User = All Circuit Groups Off, ViewOnly = All Circuit Groups Off.)
Notes:
• In order to use this feature, Circuit Groups must first be defined as described
in Section 5.6.
• Administrator and SuperUser level accounts will always have access to all
circuit groups.
• User Level accounts will only have access to the circuit groups that are
defined via the Circuit Group Access parameter.
• ViewOnly accounts are allowed to display the On/Off status of circuit groups
via the Circuit Status Screen, but are limited to the circuit groups specified
by the account. ViewOnly accounts are not allowed to invoke switching and
reboot commands.
• ServiceAccess: Determines whether this account will be able to access command
mode via Serial Port, Telnet/SSH or Web. For example, if Telnet/SSH Access is
disabled for this account, then this account will not be able to access command
mode via Telnet or SSH. (Default = Serial Port = On, Telnet/SSH = On,
Web = On.)