User`s guide

17-6
Command Reference Guide
/ON Switch Circuit(s) ON
Switches selected circuits(s) or Circuit Group(s) On, as described in Section 9.2.2.
When the /ON command is used to switch more than one circuit, Boot/Sequence Delay
Period will be applied as described in Section 5.7.
Note: When this command is invoked in Administrator Mode or SuperUser
Mode, it can be applied to all RPC circuits and Circuit Groups. When this
command is invoked in User Mode, it can only be applied to the circuits and/or
Circuit Groups that have been enabled for the account.
Availability: Administrator, SuperUser, User
Format: /ON <s>[,Y] [Enter]
Where:
s The number or name of the circuit(s) or Circuit Group(s) that you intend to
Switch On. To apply the command to several circuits, enter a plus sign (+)
between each circuit number. To apply the command to a range of
circuits, enter the numbers for the first and last circuits in the range,
separated by a colon character (:). To apply the command to all circuits
allowed by your account, enter an asterisk character (*).
,Y (Optional) Suppresses the command confirmation prompt.
Example:
Assume that your account allows access to Circuit A2 and Circuit A3. To switch Circuits
A2 and A3 On, without displaying the optional command confirmation prompt, invoke
following command line:
/ON A2+A3,Y [Enter]