User`s guide

17-5
Command Reference Guide
17.3.2. Control Commands
/X Exit Command Mode
Exits command mode. When issued at the Network Port, also ends the Telnet session.
Note: If the /X command is invoked from within a configuration menu, recently
defined parameters may not be saved. In order to make certain that parameters
are saved, always press the [Esc] key to exit from all configuration menus and
then wait until "Saving Configuration" message has been displayed and the
cursor has returned to the command prompt before issuing the /X command.
Availability: Administrator, SuperUser, User, ViewOnly
Format: /X [Enter]
/BOOT Initiate Boot Cycle
Initiates a boot cycle at the selected circuit(s) or Circuit Group(s). When a Boot cycle is
performed, the RPC will first switch the selected circuit(s) Off, then pause for the user-
defined Boot/Sequence Delay Period, then switch the circuit(s) back on. The /BOOT
command can also be entered as /BO.
Note: When this command is invoked in Administrator Mode or SuperUser
Mode, it can be applied to all RPC circuits and Circuit Groups. When this
command is invoked in User Mode, it can only be applied to the circuits and/or
Circuit Groups that have been enabled for the account.
Availability: Administrator, SuperUser, User
Format: /BOOT <s>[,Y] [Enter] or /BO <s> [Enter]
Where:
s The number or name of the circuit(s) or Circuit Group(s) that you intend to
boot. To apply the command to several circuits, enter a plus sign (+)
between each circuit number. To apply the command to a range of
circuits, enter the numbers for the first and last circuits in the range,
separated by a colon character (:). To apply the command to all circuits
allowed by your account, enter an asterisk character (*).
,Y (Optional) Suppresses the command confirmation prompt.
Example:
Assume that your account allows access to Circuit A2 and Circuit A3. To initiate a boot
cycle at Circuits A2 and A3, without displaying the optional command confirmation
prompt, invoke either of the following command lines:
/BOOT A2+A3,Y [Enter] or /BO A2+A3,Y [Enter]