User`s guide

9-5

Operation

9.2.2. Applying Commands to Several Circuits - Text Interface

As described below, switching and reboot commands can be applied to only one

Switched AC Circuit, or to an assortment of circuits.

Note: When switching and reboot operations are initiated, Boot/Sequence

Delay times will be applied as described in Section 5.7.

1. SwitchSeveralCircuits: To apply a command to several circuits, enter the

numbers of the desired circuits, separated by commas or plus signs. For example

to switch circuits A1, A3, and A4 Off, enter either of the following commands:

/OFF A1+A3+A4 [Enter]

/OFF A1,A3,A4 [Enter]

Note: In order for the "+" or "," operators to work, there must be no spaces

between the circuit name or number and the plus sign or comma.

2. SwitchaSeriesofCircuits: To apply a command to a series of circuits, enter the

numbers for the circuits that mark the beginning and end of the series, separated

by a colon. For example to switch On circuits A1 through A4 enter the following:

/ON A1:A4 [Enter]

4. AllCircuits: To apply a command to all circuits, enter an asterisk in place of the

name or number. For example, to Boot all circuits, enter the following:

/BO * [Enter]

Note: When this command is invoked by a User level account, it will only be

applied to the circuits that are specifically allowed for that account.