User manual

This document is the property of WESTERN CO. Ltd. -
All rights are reserved
Management of primary and secondary battery
On camper or boat electrical systems there are two batteries:
services
when the vehicle is stationary with the engine off.
The battery for services has to be connected to battery 1 (primary) of WRM15 dualB whereas the starter battery
be connected on the input of battery 2 (secondary). WRM15 dualB
load the one or the other in compliance of the
will be loaded battery 1 first and in this case the voltage of battery 1 reaches the
Tabs period. After that
the load for battery 1 is deactivated and is maintained
contrary when the voltage of battery 1 goes below this thereshold its load is reactivated.
When th
e voltage of battery 2 goes below the
be activated the charge on battery 2 up to the attainment of the charging
Tabs, VExitFloat, AlertVBatt2
parameters are settab
Pic
3.
Bluetooth® control
Through an Android or Apple portable device w
available for free on
Google Play
settings on WRM15 dualB.
WRM15
dualB
USER MANUAL
All rights are reserved
-
Reproduction and use of information contained Within this document is forbidden without the written consent of
Management of primary and secondary battery
On camper or boat electrical systems there are two batteries:
one for the engine
/starter and the other for
when the vehicle is stationary with the engine off.
The battery for services has to be connected to battery 1 (primary) of WRM15 dualB whereas the starter battery
be connected on the input of battery 2 (secondary). WRM15 dualB
monitors
the voltage of both batteries and choose to
load the one or the other in compliance of the
logic showed in Pic. 3. If there aren’t alarm condition on battery 2 then
will be loaded battery 1 first and in this case the voltage of battery 1 reaches the
charging end (
the load for battery 1 is deactivated and is maintained
superior than
contrary when the voltage of battery 1 goes below this thereshold its load is reactivated.
e voltage of battery 2 goes below the
AlertVBatt2 threshold, independently
from the voltage of battery 1,w
be activated the charge on battery 2 up to the attainment of the charging
end voltage
(Veoc).
parameters are settab
le through Bluetooth interface.
3.
Management of battery 1 and battery 2
Through an Android or Apple portable device w
here is installed the APP named
Western CO.
Google Play
or Apple Store, is possible to check
the working status and
Rev. 1.1
20/06/2016
Reproduction and use of information contained Within this document is forbidden without the written consent of
WESTERN CO. Ltd.
1
5
/starter and the other for
on-board
The battery for services has to be connected to battery 1 (primary) of WRM15 dualB whereas the starter battery
has to
the voltage of both batteries and choose to
logic showed in Pic. 3. If there aren’t alarm condition on battery 2 then
charging end (
Veoc) maintained for a
superior than
VExitFloat voltage. On the
from the voltage of battery 1,w
ill
(Veoc).
Western CO.
Regulator Monitor
the working status and
set up some