Technical data

www.westermo.com Theoretical and general applications 75
6. Once these settings have been made
HyperTerminal is configured. Further settings
can be made from the File menu, Properties.
Here you can select, among others to emu-
late different terminals, i.e. VT100. Using the
ASCII-settings button it is possible to set the
conditions for character, line feed and local
echo.
Com 1 9600 8N1 - Hyper Terminal
File Edit Wiew Call Transfer Help
New Connection
Open...
Save
Save As...
Page Setup...
Print...
Exit Alt+F4
Properties
7. HyperTerminal is now ready for use, as the telecom modem uses
AT-commands for configuration you can check whether contact with
the modem has been established by typing:
… AT followed by <return>
… The modem should then respond with OK.
OK is the result code from the modem that indicates that the command has
been executed; the command also automatically sets the speed, number of
bits, parity and stop bit on the modem.
As connection has now been established between HyperTerminal and the
modem, you can now configure the modem. You should also remember to take
into consideration the properties that the modem shall communicate with in the final
application.
B A C K