Installation guide

V3.8
OnTime Industrial Ethernet
U/R/T200 series Installation Guide
- 20 -
After choosing one of the switches to be the FRNT Primary switch it will appear like the first
one in the list below. For further information about FRNT v0 see section 3.1
Figure 12
If the ring should be broken the Status of the Focal Point switch will change from RING to
BUS. An exclamation mark will be shown on the ports that have lost connection.
Figure 13
• Scanning For
Devices Highlights
All Switches On
Ring
• Highlights FP
Running Network
As A ‘Ring’
• Highlights Network
Focal Point
• Switch software
version
• Scanning For
Devices Highlights
All Switches On
Ring
• Ring Failure
Occurred
• FP Now Running
As Bus
• Highlights Link /
Port That Have
Failed