Specifications



DHCPClient:YoucanselecttoEnableorDisableDHCPClientfunction.When

DHCPClientfunctionisenabled,anIPaddresswillbeassignedtotheswitchfrom

thenetwork’sDHCPserver.Inthismode,thedefaultIPaddresswillthereforebe

replacedbytheoneassignedbyDHCPserver.IfDHCPClientisdisabled,thenthe

IPaddressthatyouspecifiedwillbeusedinstead.

IPAddress:YoucanassigntheIPaddressreservedbyyournetworkforyourPMI.

IfDHCPClientfunctionisenabled,youdon’tneedtoassignanIPaddresstothe

PMI,asitwillbeoverwrittenbyDHCPserverandshownhere.ThedefaultIPis

192.168.2.200.

SubnetMask:YoucanassignthesubnetmaskfortheIPaddresshere.IfDHCP

Clientfunctionisenabled,youdon’tneedtoassignthesubnetmask.Thedefault

SubnetMaskis255.255.255.0.

Note:IntheCLI,weusetheenabledbitofthesubnetmasktorepresentthe

numberdisplayedinwebUI.Forexample,8standsfor255.0.0.0;16standsfor

255.255.0.0;24standsfor255.255.255.0.

DefaultGateway:Youcanassignthegatewayfortheswitchhere.Note:InCLI,

weuse0.0.0.0/0torepresentforthedefaultgateway.



Onceyoufinishconfiguringthesettings,clickonApplytoapplyyour

configuration.

IPv6Configuration–AnIPv6addressisrepresentedaseightgroupsoffour

hexadecimaldigits,eachgrouprepresenting16bits(twooctets).Thegroupsare

separatedbycolons(:),andthelengthofIPv6addressis128bits.

AnexampleofanIPv6addressis:2001:0db8:85a3:0000:0000:8a2e:0370:7334.