Specifications


3 PreparationforManagement
PMIIndustrialManagedPoESwitchprovidesbothin‐bandandout‐band
configurationmethods.YoucanconfiguretheswitchviaRS232consolecableif
youdon’tattachyouradminPCtoyournetwork,orifyoulosenetwork
connectiontoyourPMIPoEManagedSwitch.Thisisso‐calledout‐band
management.Itwouldn’tbeaffectedbynetworkperformance.
Thein‐bandmanagementmeansyoucanremotelymanagetheswitchviathe
network.YoucanchooseTelnetorWeb‐basedmanagement.Youjustneedto
knowthedevice’sIPaddressandyoucanremotelyconnecttoitsembedded
HTTPwebpagesorTelnetconsole.
Followingtopicsarecoveredinthischapter:
3.1 PreparationforSerialConsole
3.2 PreparationforWebInterface
3.3 PreparationforTelnetconsole

3.1 PreparationforSerialConsole
Intheunitpackage,WestermoattachedoneRJ‐45toRS‐232DB‐9console
cable.PleaseattachRS‐232DB‐9connectortoyourPC’sCOMport,connect
RJ‐45connectortotheConsoleportofthePMIPoEManagedSwitch.Ifthe
serialcableislost,pleasefollowtheserialconsolecablePINassignmenttofind
one.(Refertotheappendix).
1. GotoStart‐>Program‐>Accessories‐>Communication‐>HyperTerminal
2. Giveanametothenewconsoleconnection.
3. ChoosetheCOMname
4. Selectcorrectserialsettings.TheserialsettingsofPMIPoEManaged
Switchesareasbelow:
BaudRate:9600/Parity:None/DataBit:8/StopBit:1
5. Afterconnected,youcanseeSwitchloginrequest.
6. Logintheswitch.Thedefaultusernameis“admin”,password,
“westermo”.





Switch login: admin
Password:
The switch (version 1.1.5-20100414-11:04:13).
Switch>
19