Specifications

2.7 DINRailmountingInstallation
TheDIN‐RailclipisalreadyscrewedtightontherearsideofPMISwitchwhenshipping.If
theDIN‐Railclipisnotscrewedontherearsidepanel,pleasecontactyourdistributorto
gettheDINrailclipset.TheDINrailclipsupportsEN50022standard.Thediagram
followingincludesthedimensionofEN50022DINrailforyourreference.
TheSwitchshouldinstall andusedatRestricedAcessLocationarea,likeasthecontrol
roomorcontrolcabinet.Besides,thedevice’ssurfacetemperaturemaycauseddamage
whilethePoweroverEthernetfunctionisenabledandunderworking,atthe ambient
temperature70°C.Therefore,thedeviceshouldinstall attherestricedlocation,likeas
Controlcabinettopreventanydamage.




Followthe stepsbelowtomountPMIManagedSwitchtotheDIN‐Railtrack:
1. First,inserttheDIN‐RailtrackuppersideintotheupperendofDIN‐Railclip.
2. LightlypushthebottomofDIN‐Railclipintothetrack.
3. CheckifDIN‐RailclipistightlyattachedtotheEN50022Railtrack.
4. ToremovePMISwitchfromthetrack,reversethestepsabove.
17