User`s manual

92
VLAN ID is used by the switch to identify different VLANs. Valid VLAN ID is
between 1 and 4094 and VLAN 1 is the default VLAN.
VLAN Name is a reference for network administrator to identify different VLANs.
The available character is 12 for you to input. If you don’t input VLAN name, the
system will automatically assign VLAN name for the VLAN. The rule is VLAN
(VLAN ID).
The steps to create a new VLAN: Type VLAN ID and NAME, and press Add to
create a new VLAN. Then you can see the new VLAN in the Static VLAN
Configuration table.
After created the VLAN, the status of the VLAN will remain in Unused until you
add ports to the VLAN.
Note: Before you change the management VLAN ID by Web and Telnet,
remember that the port attached by the administrator should be the member
port of the management VLAN; otherwise the administrator can’t access the
switch via the network.
Note: Currently the switch only support max 64 group VLAN.
Static VLAN Configuration
You can see the created VLANs and specify the egress (outgoing) port rule to be.
Untagged or Tagged here.
Figure 4.5.2.3 Static VLAN Configuration table. You can see that new VLAN 3 is
created. VLAN name is test. Egress rules of the ports are not configured now.
Figure 4.5.2.4 Configure Egress rule of the ports.
-- : Not available
U: Untag: Indicates that egress/outgoing frames are not VLAN tagged.
T : Tag: Indicates that egress/outgoing frames are to be VLAN tagged.