User`s manual

87
Ethernet loop protection is enabled on all interfaces!
Switch(config)# loop-protect transmit-interval
<1-10> Valid range is 1~10 second(s)
Switch(config)# loop-protect transmit-interval 3
(set interval time – 3 seconds)
Switch(config)# loop-protect enable fa6  (fa1~7,
gi7~gi10)
Set fa6 Ethernet loop protection enabled!
Switch# sh loop-protect (show current loop-protect
detected information)
Loop protect information :
Loop Protect Interface : fa6,gi10
Transmit Interval(sec) : 3
Loop Detected Interface : N/A