User`s manual

Transmit interval: setting the detect duration time between detect packet.

Loop Protection: Enable/ Disable Loop Protection function by per port.

Status: shows the port status. If there is looping occurred, it will show “Loop

Detected and Disabled” information and the link indicator will not turn-off, and

also the port is disabled by system. Once the looping is fixed, the blocked port

will keep at blocked state, and must be enabled by manual or perform system

reset to recovery it.

Reload: refresh and update the port status information.

4.4.10 Command Lines:

Feature

Command Line

Global (STP, RSTP, MSTP)

Enable

Switch(config)# spanning-tree enable

Disable

Switch (config)# spanning-tree disable

Mode (Choose the

Spanning Tree mode)

Switch(config)# spanning-tree mode

rst the rapid spanning-tree protocol (802.1w)

stp the spanning-tree prtotcol (802.1d)

mst the multiple spanning-tree protocol (802.1s)

Bridge Priority

Switch(config)# spanning-tree priority

<0-61440> valid range is 0 to 61440 in multiple of