User`s manual

67
more bridges (i.e. it is served by a shared-medium LAN segment). This function
allows link status of the link to be manipulated administratively. “Auto” means to
auto select P2P or Share mode. “P2P” means P2P is enabled, the 2 ends work in
Full duplex mode. While “Share” is enabled, it means P2P is disabled, the 2 ends
may connect through a share media and work in Half duplex mode.
Edge: A port directly connected to the end stations cannot create a bridging loop
in the network. To configure this port as an edge port, set the port to the Enable
state. When the non-bridge device connects an admin edge port, this port will be
in blocking state and turn to forwarding state in 4 seconds.
Once you finish your configuration, click on Apply to save your settings.
4.4.3 STP Info
This page allows you to see the information of the root switch and port status.
Root Information: You can see root Bridge ID, Root Priority, Root Port, Root Path
Cost and the Max Age, Hello Time and Forward Delay of BPDU sent from the root
switch.