User`s manual

61
Bandwidth
<0-100> Limit in magabits per second (0 is no limit)
Switch(config-if)# rate-limit ingress bandwidth 8
Set the ingress rate limit 8Mbps for Port 1.
Port Trunking
LACP
Switch(config)# lacp group 1 gi8-10
Group 1 based on LACP(802.3ad) is enabled!
Note: The interface list is fa1,fa3-5,gi8-10
Note: different speed port can’t be aggregated together.
LACP – Port
Setting
Long/Short
Timeout
SWITCH(config-if)# lacp
port-priority LACP priority for physical interfaces
timeout assigns an administrative LACP timeout
SWITCH(config-if)# lacp port-priority
<1-65535> Valid port priority range 1 - 65535 (default
is 32768)
SWITCH(config-if)# lacp timeout
long specifies a long timeout value (default)
short specifies a short timeout value
SWITCH(config-if)# lacp timeout short
Set lacp port timeout ok.
Static Trunk
Switch(config)# trunk group 2 fa6-7
Trunk group 2 enable ok!
Failure to configure due to the group ID is existed.
SWITCH(config)# trunk group 1 fa11-12
Can't set trunk group 1 enable!
The group 1 is a lacp enabled group!
SWITCH(config)# trunk group 2 fa11-12
Can't set trunk group 2 enable!
The group 2 is a static aggregation group.
Switch(config)# trunk group 2 fa6-7
Trunk group 2 enable ok!
Display - LACP
Switch# show lacp internal
LACP group 1 internal information:
LACP Port Admin Oper Port
Port Priority Key Key State
----- ----------- -------- -------- -------
8 1 8 8 0x45