User`s manual

31
4.2 Basic Setting
The Basic Setting group provides you to configure switch information, IP address,
user name/password of the system. It also allows you to do firmware upgrade,
backup and restore configuration, reload factory default, and reboot the system.
Following commands are included in this section:
4.2.1 Switch Setting
4.2.2 Admin Password
4.2.3 IP Configuration
4.2.4 Time Setting
4.2.5 DHCP Server
4.2.6 Backup and Restore
4.2.7 Firmware Upgrade
4.2.8 Factory Default
4.2.9 System Reboot
4.2.10 CLI Commands for Basic Setting
4.2.1 Switch Setting
You can assign System name, Location, Contact and view system information.
Figure 4.2.1.1 – Web UI of the Switch Setting
System Name: You can assign a name to the switch. The number of characters
you can input is 64. After you configure the name, CLI system will select the first
12 characters as the name in CLI system.
System Location: You can specify the switch’s physical location here. The number
of characters you can input are 64.
System Contact: You can specify contact people here. You can type the name,
mail address or other information of the administrator. The available characters
you can input are 64.
System OID: The SNMP object ID of the switch. You can follow the path to find its