User`s manual

1 Laser/LED Diode.

Note: It is recommended not to plug in SFP fiber transceiver and link up RJ-45

port at same time, it might cause the connection does not work properly.

2.9 Wiring RS-232 Console Cable

Westermo attaches one RS-232 DB-9 to RJ-45 cable in the box. Connect the DB-9

connector to the COM port of your PC, open Terminal tool and set up serial

settings to 9600, N,8,1. (Baud Rate: 9600 / Parity: None / Data Bit: 8 / Stop Bit: 1)

Then you can access the CLI interface using the console cable.

Note: If you have lost the cable, please contact your sales office or follow the pin

assignment to buy/make a new one. The pin assignment spec is listed in the

appendix.

2.10 DIN-Rail Mounting Installation

The DIN-Rail clip is already attached to the switch when packaged. If the DIN-Rail

clip is not screwed on the switch, follow the instructions and the figure below to

attach the DIN-Rail clip to the switch.

Follow the steps below to mount the switch on a DIN-Rail track:

1. First, insert the upper end of the DIN-Rail clip into the back of the DIN-Rail

track from its upper side.

1. Use the screws to attach DIN-Rail clip to the rear panel.

2. To remove DIN-Rail clip, reverse step 1.