User`s manual

138
4.11.2 Event Selection
Event Types can be divided into two basic groups: System Events and Port Events.
System Events are related to the overall function of the switch, whereas Port
Events related to the activity of the specific ports
System Event
Warning Event is sent when…..
Device Cold Start
Power is cut off and then reconnected.
Device Warm Start
Reboot the device by CLI or Web UI.
Power 1 Failure
Power 1 is failure.
Power 2 Failure
Power 2 is failure.
Authentication failure
An incorrect password, SNMP Community String is
entered.
Time Synchronize Failure
Accessing to NTP Server is failure.
Fault Relay
The DO/Fault Relay is on.
Ring Event
Master of Super Ring has changed or backup path is
activated.
DI1 Change
The Digital Input#1 status is changed.
DI2 Change
The Digital Input#2 status is changed.
SFP DDM Failure
The readed information of DDM SFP transceiver is
over temperature or out the range of TX/RX power.
Loop Protection
Port Looping is detected.
Port Event
Warning Event is sent when…..
Link-Up
The port is connected to another device
Link-Down
The port is disconnected (e.g. the cable is pulled out,
or the opposing devices turns down)
Both
The link status changed.