User`s manual

130
Sever Timeout: The timeout for server response for authenticating.
Once you finish configuring the settings, click on Apply to apply your
configuration.
Click Initialize Selected to set the authorize state of selected port to initialize
status.
Click Reauthenticate Selected to send EAP Request to supplicant to request
reauthentication.
Click Default Selected to reset the configurable 802.1x parameters of selected
port to the default values.
802.1X Port Status
The user can observe the port status for Port control, Authorize Status,
Authorized Supplicant and Oper Control Direction on each port.
4.10.4 CLI Commands of the Security
Command Lines of the Security configuration
Feature
Command Line
Http / Telnet Security (only available for command line interface)
Telnet service security
Switch# show service ; show current service
status
System service
Telnet : Enabled
Http : Enabled
Switch(config)# service telnet ; it is
recommended operating via local console
interface only.
disable Disable telnet service ; stop service
request from TCP port #23.
enable Enable telnet service; enable service
request from TCP #23