User guide

Removal
Removing Lynx with screwed on DIN-clip: Press the device upwards to compress locking
spring, tilt forward to unhook device from DIN-rail.
Cooling
This unit uses convection cooling.
To avoid obstructing the airflow
around the unit, use the following
spacing rules. Minimum spacing 25 mm
(1.0 inch) above / below and 10 mm
(0.4 inches) left / right the unit.
Spacing is recommended for the use
of unit in full operating temperature
range and service life.
8
ON
7
5
3
1
6
4
2
DC 1
DC 2
ST 1
ST 2
FRNT
Lynx
8
ON
7
5
3
1
6
4
2
DC 1
DC 2
ST 1
ST 2
FRNT
Lynx
8
ON
7
5
3
1
6
4
2
DC 1
DC 2
ST 1
ST 2
FRNT
Lynx
10mm 10mm
Removing Lynx with integrated DIN-clip:
Press down the support at the back of the unit using a screwdriver. See figure.