User guide

6640-2205

Configuration

The units can easily be configured via the onboard Web based configuration tool. Local IP

addresses can also be configured by using the Westernmo IP Configuration tool, from the

IP Configuration tool it is then possible to browse into the unit for further configuration.

IP Address

When delivered, the default IP address of the Lynx is 192.168.2.200.

Default gateway 192.168.2.200

If the default address of the unit is valid in the connected network it is possible to access

the unit directly from a web browser.

Change local IP address

The local address of Lynx can be configured using the IP Configuration tool, then it is

possible to browse into the unit for further configuration. The IP Configuration program

is available on the CD or for download from the WESTERMO web page:

http://www.westermo.com, choose Downloads/Software/Ethernet/Ethernet switches

Name: IP config Westermo.zip

Install the software and start the application from a PC on the network connected to

the same network as the Lynx. Make sure that the Default IP of the configuration soft-

ware (see figure below) is in the same subnet as your PC.

Note! If you are not sure about the subnet – consult your network administrator.

Note! IP Config version must be 10.0.0 or higher.

Figure 1

Help About

Scan for devices

Default IP:

Device list:

IP Adress

Subnet Mask

MAC Adress SW Ver Type Status

192. 168. 2. 200

192.168.2.200 255.255.255.0 00-07-7C-80-4A-6C 3.15 Lynx

Mask:

255. 255. 255. 0

IP configuration