Specifications

4 www.westermo.com
The Westermo GD-Tool provides two ways to congure our
GSM/GPRS modems. AT commands can be entered into a ter-
minal window or the user friendly GD-tool conguration screens
can be used.
To use GD-tool rstly a serial connection must be made to the
modem with a standard cable. Next the GD-tool
is started on the PC. Options are provided to
either Auto-connect or Reconnect and the tool
will automatically download parameters about
the current conguration.
The tool offers several conguration menus:
Connection …
Basic …
Serial …
GPRS …
Signal …
Diagnostic …
The Diagnostics screen provides vital help for any service techni-
cian trying to diagnose a fault with a connection.
Conguration les can be saved onto a PC so once the correct
conguration is found a particular brand of PLC
for instance this can be saved and then
downloaded into other modems to speed up
and simplify future installations.
The possibility to save a conguration le makes it very conve-
nient for e.g. a system integrator who works with different brands
of PLC’s. Just make the conguration ones for each specic device
and save the le and then download the le to the next modem.
GD-Tool
The Easy way to Configure Modems
File Connection Tool Help
GD-Tool
Connection
Connection Settings
Search for a supported Westermo
modem on the selected COM port.
This make take several minutes.
Aut
Autoconnect
Reconnect
Disconnect
Open
Connects to a supported Westermo
modem, using current settings.
Closes the COM port, and disconnects
any connected modem.
Opens the COM port with current
settings for the terminal window.
Connection
Status:
Port:
Baud rate:
Data bits:
Stop bits:
Modem:
SIM card:
Connected
1
115200
Connected...
8
1
Paity: None
GDW-11
Ok
COM Port
Baud rate
1
115200
Parity
None
Data bits
8
Stop bits
1
Basic Serial SMS GPRS Signal Diagnostic
File Connection Tool Help
GD-Tool
Connection
Information
Revision identification [ATI3]
Basic
Serial
657c09gg.Q2406B 1956992 042407 11:29
Westermo Software revision [ATI9]
SW version: 4100-9403, Jul 13 2007, 13:46:54
IMEI [+CGSN]
357832000022553
Network Registration [+CREG]
0,2
GPRS Network Reg. [+CGREG]
0,0
GPRS status [”WIPSTATUS]
IP stack state: DISCONNECTED
Current local IP: none
Modem Configuration [AT&V]
Q:0 V:1 S0:000 S2:043 S3:013 S4:010 S5:008
+CR:0 +CRC:1 +CMEE:1 +CBST:0,0,1
+SPEAKER:0 +ECHO:0,1 &C:1 &D:2 %C:0
+IPR:115200 +ICF:3,4 +IFC:2,2
GPRS Configuration [”WTCPV]
“WGPRSAPN: ”static. voafone.net”
“WGPRSUN: ””
“WGPRSPW: ””
“WTCPSERV: ”255.255.255”
“WTCPCLIENTIP: ”0.0”
“WTCPPORT: 13618
”WTCPTXDELAY: 11829
“WTCPMODE: 0
”WTCPPINGSYNC: 20,0,0
“WTCPCONNECT: 0
Diagnostic
Connected...
Reload
Create Report
Connection
Status:
Port:
Baud rate:
Data bits:
Stop bits:
Modem:
SIM card:
Connected
1
115200
8
1
Paity: None
GDW-11
Ok
SMS GPRS Signal
Connection Tool Help
GD-Tool
Connection mode [”WTCPMODE]
0 - Client
Delay [”WTCPTXDELAY]
11829
IP Server [”WTCPSERV]
Password [”WGPRSPW]
PRSAPN]
TCP connect status information [”WTCPI]
0 - No status information
On 0 0
255 . 255 . 0 . 255 13618
State
1 - Attached
Auto connect [”WTCPCONNECT]
0 - Disabled
Autoconnect sync [”WTCPPINGSYNC]
Mode Delay Idle
0 . 0 . 0 . 0
Client IP [”WTCPCLIENTIP]
Connected...
GPRS attach/detach [+CGATT]
ReadChange
Write
GPRS TCP
Start Stop
Connect
Ping
GPRS
SignalSMS Diagnostic
Connection
Status:
Port:
Baud rate:
Data bits:
Stop bits:
Modem:
SIM card:
Connected
1
115200
8
1
Paity: None
GDW-11
Ok
Ping
File
New Profile
Open Profile
Save Profile
Close Profile
Write Profile to modem
Exit Alt+F4
Close Profile
File Connection Tool Help
GD-Tool
Read
Write
Connection
Security [+CPIN],[+CLCK] & [+CPWD] Factory Settings [&F]
Rings to auto-answer [S0]
000
Delay [hhh:mm] Time to reset [hhh:mm] [+CFUN=1]
Basic
Serial
Call
PIN
Enabled
Enabled
Auto PIN [”WPIN] OpenAT
Connected...
0 - Autobauding
Reset [+WRST]
SMS GPRS Signal Diagnostic
Enter PIN
Enter PIN
Change PIN Enable PIN Factory
Disable
Reset Now
Set DTR Toogle Event [%D]
TestActivate Deactivate
Data
Bearer type - speed [+CBST]
1 - Non transparant only
Bearer type - ce [+CBST]
0 - No compression
Select DTR Event
Compression [%C]
0 - No error correction
Error Connection Mode [\n]
0 - No error correction
Status led [”WSTATLED]
Connection
Status:
Port:
Baud rate:
Data bits:
Stop bits:
Modem:
SIM card:
Connected
1
115200
8
1
Paity: None
GDW-11
Ok
AUDIN - 8, avenue de la malle - 51370 Saint Brice Courcelles
Tel : [phone] - Fax : [phone] - Web : http: www.audin.fr - Email : [e-mail]