User guide

6622-2231 • 29000448

DR-260

DSL Router

SIM 1

SIM 2

PWR

0 WLAN DTE DSL1 2 3 NET SIMDAT

3G/GPRS

LAN

SIGNAL

DB1B2

OH CD DAT

ISDN

PSTN

Step-by-step guide to configure a DSL-connection

using the web interface

Power Connection

ADSL

connection (RJ-11)

PC/Ethernet

connection (RJ-45)

Step 1 – Power-up the unit and wait for it to become ready

Connect the DR-260 to the DSL-network using the RJ-11, connect an RJ-45 cable from

one of the four Ethernet-ports to your PC, and then connect the unit to an appropriate

PSU and power it up.

The unit will start to negotiate the DSL-connection after approximately 15 – 20 seconds,

please note that the default settings might not be appropriate for your specific connec-

tion. Continue reading in order to assure that you have a valid setup.

Step 2 – Configure your PC

Make the following changes in your PC.

IP address 192.168.2.100*

Netmask (Ethernet ports) 255.255.255.0

Gateway 192.168.2.200

Preferred DNS server 192.168.2.200

* Can be any address in the 192.168.2.0-255-range except 192.168.2.200.

Note! If you are unsure or unable to change the above – consult your network

administrator.