DR-260 DR-260 DSL Router LAN SIM 1 SIM 2 3G/GPRS PWR 0 1 2 3 WLAN DTE DSL NET SIM DAT SIGNAL ISDN D OH B1 B2 CD DAT PSTN ADSL / ADSL2 / ADSL2+ Router www.westermo.
Legal information The contents of this document are provided “as is”. Except as required by applicable law, no warranties of any kind, either express or implied, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose, are made in relation to the accuracy and reliability or contents of this document. Westermo reserves the right to revise this document or withdraw it at any time without prior notice.
Safety ! Before using this unit: Read this manual completely and gather all information on the unit. Make sure that you understand it fully. Check that your application does not exceed the safe operating specifications for this unit. Hazardous voltages may occur within this unit when connected to a power supply. Prevent access to hazardous voltages by disconnecting the unit from its power supply.
General Remember to follow any special regulations and warnings in force in any area and never use the unit whenever it’s forbidden to use it. Do not use the unit when it may cause interference or danger. A wireless device exposed to interference above specified limits could result in deteriorated performance. Hospitals or other Medical environment Do not use the unit in a medical environment such as health care facilities. Follow any regulations or rules that instruct you to not use the unit.
For Vehicles equipped with an airbag An air bag inflates with great force. DO NOT place objects, including either installed or portable wireless equipment, in the area over the air bag or in the air bag deployment area. If in-vehicle wireless equipment is improperly installed and the air bag inflates, serious injury could result. Blasting areas Do not use the unit where blasting is in progress or in “blasting areas”. Observe restrictions and follow any regulation or rules.
Agency approvals and standards compliance Type Approval / Compliance EN 55024, EN 55024 A1, EN 55024 A2, Electromagnetic compatibility Immunity IT equipment EMC EN 55022, EN 55022 A1, Information technology equipment. Radio disturbance characteristics. Limits and methods of measurement FCC part 15 Class B Safety IEC / EN 60950-1, IT equipment Article 3.1a Article 3.1b R&TTE Article 3.
Declaration of Conformity Westermo Teleindustri AB Declaration of conformity The manufacturer Westermo Teleindustri AB SE-640 40 Stora Sundby, Sweden Herewith declares that the product(s) Type of product Cellular router Model DR-260A series Art no 3622-0210, 3622-0220, 3622-0230 Cellular router DR-260B series 3622-0240, 3622-0250, 3622-0260, 3622-0270, 3622-0280 is in conformity with the following EC directive(s).
Type tests and environmental conditions Phenomena Test Description Test levels ESD EN 61000-4-2 Enclosure contact ± 4 kV Enclosure air ± 8 kV RF field AM modulated EN 61000-4-3 Enclosure 3 V/m 80% AM (1 kHz), 80 – 1 000 MHz, 1 400 MHz – 2 000 Fast transient EN 61000-4-4 Signal ports ± 0.5 kV Power ports ± 1 kV Telecom/Signal ports ± 0.
Description The DR-260-series is a multiple media ADSL router that provide the users with not only a highly robust and fast ADSL-connection with all the ADSL-standards covered (ADSL to ADSL2+) but also with the option of having multiple backup paths for redundancy, either via cellular networks (GPRS/3G) or via legacy PSTN/ISDN connections.
Interface specifications Power Rated voltage Operating voltage Rated current (max) Rated frequency 11 – 28 VDC 11 – 28 VDC 1500 mA @ 12 VDC DC RS-232 Electrical specification Data rate Data format Protocol Circuit type Transmission range Connection Shielded cable Conductive housing Number of ports EIA RS-232 300 bit/s – 115.
Antenna (option) Frequency bands Connection 850 MHz – 2100 MHz SMA female, impedance: 50 ohm SIM (option) Electrical specification Number of slots 3 volts SIM supported 2 USB Electrical specification Data rate Circuit type Maximum supply current Connection Number of ports USB 2.0 host interface Up to 12 Mbit/s (full-speed mode) SELV 500 mA in total for both ports USB receptacle connector type A 2 DSL Data rate Protocol Connection Shielded cable Number of ports Standard ITU-T G.992.1 (ADSL) ITU-T G.
Connections SIM Card Sockets The two sockets at the left side of the front panel are for the GSM SIM card(s) that you will receive from your service providers. SIM 1 and SIM 2 cannot be used to access two networks simultaneously. The SIM card(s) should be inserted into SIM cardholders on the right of the front panel as illustrated below. In both cases, the end of the SIM card with the chamfered corner should be inserted first. For SIM 1 the contacts should be face down.
LED Indicators LED Status Description PWR OFF Unit has no power GREEN All OK RED Lit until unit has started up OFF No link GREEN Link established GREEN FLASH Data traffic indication WLAN N/A N/A DTE OFF GREEN FLASH No connection on serial port, or no data is transmitted or received on the serial port Terminal connected to the serial port and the DTR signal is on Data is transmitted or received on the serial port.
Protocols and Functionality Ethernet Technologies IEEE 802.3 for 10BaseT IEEE 802.3u for 100BaseTX ADSL Technologies ITU-T G.992.1 ADSL (Annex A, B (non overlap)) ITU-T G.992.2 ADSL Lite (Annex A (non overlap)) ITU-T G.992.3 ADSL2 (Annex A, B, I, J, L, M (non overlap)) ITU-T G.992.5 ADSL2+ (Annex A, B, I, J, M (non overlap)) RFC2684 Bridged LLC and Bridged VC-MUX ATM encap.
Manageability Management tools • Web interface (HTTP and HTTPS) • Command Line Interface (CLI) via console port, SSHv2 and TELNET • SNMPv1/v2c/v3 • Powerful Packet/Protocol Analyzer with PCAP-export support • Flexible management of configuration and log files • Local file management via HTTP, FTP, TFTP and SCP • Load/save files from/to USB memory stick • Upgrade firmware from USB memory stick Flexible alarm/event handling system Syslog (log files and remote syslog server) Port Monitoring SN
Factory default/reset Perform the following 4 steps to reset the unit to its factory default settings. 1. Power up the unit. 2. Locate the reset switch on the underside of the unit, near the front ventilation holes. 3. Press and hold the reset switch gently, with the tip of a pen or other similar device, until you see the front LEDs flashing (~5 sec). 4. Remove the tip of the pen and wait for the unit to reboot.
DR-260 Step-by-step guide to configure a DSL-connection using the web interface DSL Router LAN SIM 1 PWR 0 1 3G/GPRS 2 3 WLAN DTE DSL SIGNAL NET SIM DAT SIM 2 D OH ISDN B1 B2 CD DAT PSTN Power Connection ADSL connection (RJ-11) PC/Ethernet connection (RJ-45) Step 1 – Power-up the unit and wait for it to become ready Connect the DR-260 to the DSL-network using the RJ-11, connect an RJ-45 cable from one of the four Ethernet-ports to your PC, and then connect the unit to an appropriate PS
Step 3 – Accessing the unit Start a web browser on your PC and type in the following address http://192.168.2.200 Step 4 – Login screen After step 3 you will be presented with a login screen which asks for a username and a password. Please type in the following Username admin Password westermo Step 5 – Welcome screen You have now successfully logged into the unit and are ready to set up your DSLconnection. Please click on Network under the Configuration-menu item.
Step 6 – Alternative 1 – DSL Setup for PPPoA (e.g. UK) / PPPoE (e.g. DE) The DR-260 comes pre-configured to match connections using ADSL with VPI/VCI set to 0/38, authentication via PPPoA. Should the default settings not match your connection you can always change the parameters to match your specific details. Then click on DSL under the Interface-context.
In the DSL setup screen you configure the DSL-broadband connection according to the information you received from your service provider. When you are done, please press Apply and then Save to save your configuration.
Step 6 – Alternative 2 – DSL Setup for DHCP / Routed access (e.g. SE) Some ISPs does not require any username or password and usually provides Internet access via DHCP. To setup the DR-260 in those countries/ISPs please follow the actions below.
Make sure that the radio-button for Get an IP address automatically using DHCP is selected.
Step 7 – Unit ready and online The DR-260 will immediately start to negotiate the DSL-connection with the new details after Step 6. To monitor the connection progress, navigate to Network Status→ Interfaces→ DSL. Under Modem Status you see the status of the DSL-connection. Step 8 – Test your connection In your Internet browser type in www.westermo.com and test your connection, you should be able to see the Westermo website.
Westermo • SE-640 40 Stora Sundby, Sweden Tel +46 16 42 80 00 Fax +46 16 42 80 01 E-mail: info@westermo.com www.westermo.com United Kingdom Westermo Data Communications Talisman Business Centre Duncan Road, Park Gate, Southampton. SO31 7GA Tel: +44 (0) 1489 580 585 • Fax: +44 (0) 1489 580 586 sales@westermo.co.uk • www.westermo.co.uk Germany Westermo Data Communications Goethe Strasse 67 DE-68753 Waghäusel Tel: +49 (0) 7254 95400-0 • Fax: +49 (0) 7254-95400-9 info@westermo.de • www.westermo.
