User's Guide

Ibex-RT-310 and Ibex-RT-320 Series User Guide
Westermo Network Technologies 17
PoE connection on X2 (Ibex
-
RT
-
31
0
-
LV
and
Ibex
-
RT
-
320
-
LV
only)
Position
Device mode A
Device mode B
1
+
DC
2
+
DC
3
-
DC
4
-
DC
5
-
DC
6
-
DC
7
+DC
8
+DC
Table 6 Ethernet X2 PoE connection
NOTE
PoE is supported on X2 for the LV product variant only.
NOTE
If the Ethernet function is not used, the protective dust cap which is part of the
delivery must be closed to protect the interface from water or dust ingress.
3.4.3 Antenna Ports
The antenna connectors are identified on the product with A1, A2 and A3. QMA industrial standard
connector is used.
A1 to A3 are used for WLAN communication. At least A1 must be connected to an external WLAN
antenna. The antenna configuration is made through the Software interface.
NOTICE
Any unused antenna ports must be properly terminated with 50-Ohms, otherwise
the device might be damaged when power is applied to a non-terminated antenna
port.
NOTE
To ensure specified IP protection, suitable QMA connectors / cables and
terminations must be used.