Specifications
GenRemote
CALIBRATION
NOTE:
THIS
DATA
APPLIES
ONLY
TO
THE
OPTIONAL
GenRemote
CONTROLS
. The unit consists
of
a
Power
Logic
Module,
Display
Panel
and
six conductor shielded Display
Cable.
The shielded cable links the display to the module
and
can be up to 300 feet long. Two
display panels can
be
daisy chained to one
(1)
module output. The module supports two display
cable outputs allowing for a total
of
four
(4)
displays
per
module. Total allowed cable length per
module, including
both
display cable outputs,
is
six-hundred
(600')
feet.
The logic module
is powered directly from the generator's cranking battery and consumes less
than
70 milli amps (7011000
of
an amp) when the generator
is
idle.
DC
operating voltage can
be
12
or
24
volts. The AC generator output can
be
115V, 240V, 50/60 Hz, single phase
(10)
or
three
(3
0)
phase.
Generator and Engine
Monitoring
1.
DC
Voltage
-
2.
Oil
Pressure
3.
Water
Temperature
4.
AC
Voltage
5.
AC
Current
L-l
6.
AC
Current
L-2
7.
Line
Frequency
Hz
8.
Engine
Hours
Up
to
10,000
Hours
9.
Exhaust
Over
Temperature
Alarm
GenRemote
is
designed
to
safely
interface
with
the
existing
engine
sensors.
The
digital
display
is
easily
calibrated
to
match
the
readings
of
the
manufacturer
supplied
mechanical
gauge
package.
The
GenRemote
circuitry
is
isolated
from
the
generators
OEM
electrical
system.
This
assures
that
GenRemote
will
not
interfere
with
the
manufacturers
supplied
gauge
package.
Electrical
isolation
also
allows
normal
generator
operation
should
the
GenRe-
mote
be
accidentally
disconnected
from
the
generator.
Electrical
Hook;'Up
Electrical hookup includes interconnecting with both the generators AC and DC systems.
TheACwires Required: The
115
volt Line One
[L-l]
is
Black
Line Two
[L-2]
is White. The 220 volt
Line
-2 [L-2 ] is BlackwithaRed Stripe. The 220 VACNeutral connection
is
White and is Not connected
to the GenRemote.
The
220 VAC Generator Neutral is the same as Green Ground wire. The 115/220 VAC Neutral [White
Color]
is
connected
to
the generator frame.
The DC Wire Harness
Supplied Color Code as follows: Green
is
Ground, White is ESS [Emergency Stop
Switch], White/Black
is
the Stop Switch, Black is Preheat, Orange is Oil Pressure, Red is Water
Temperature, Yellow
is
the Exhaust High TemperatureAiarm [marine applications only] andBlack/Red
..
is the Start Button.
,
IMPORTANT!
The Exhaust High Temp terminal is connected to the ESS terminal when
it
is not used.
Engines & Generators
55