Specifications

ENGINE ADJUSTMENTS
ELECTRONIC GOVERNOR (OPTIONAL)·
The Electronic Governor regulates the engine speed by
sensing the engine's
RPM with a magnetic pick-up at the
flywheel. The governor's controller continuously monitors
the engines speed and if there
is any discrepancy, the
controller signals the actuator and the actuator adjusts the
engine
to the desired speed electronically.
Actuator
ENGINE MOUNTING
SURFACE
The following instructions are for adjusting or replacing
the actuator.
1. Shut-off the DC power to the generator.
2.
Disconnect the actuator wires from the wiring harness.
3. Measure the distance between the actuator and the engine
mounting surface
as shown.
ACTUATOR
MEASURE FOR
REFERENCE
ENGINE MOUNTING
. SURFACE
-JAM NUT
4. Back-offthe 1 7/16" jam nut and unscrew the actuator.
5. Apply a small amount of teflon sealant to the replacement
actuator and screw the actuator into the engine's
mounting
boss. Maintain the same distance between the
actuator and the engine mounting surface
as previously
measured Secure the actuator's position with the jam nut.
(The standard distance is 13/16" to 7/8").
6. Reconnect the actuator wires and test the unit.
SCREW IN TO
ORIGINAL MEASUHE
~---13!16" TO 7/8"
STANDARD
NOTE: For additional information and Electronic Governor
Troubleshooting, refer to
your WESTERBEKE Service Manual.
Engines & Generators
21