Installation manual

ENGINE ADJUSTMENTS
ELECTRONIC GOVERNOR (OPTIONAL)
The Electronic Governor regulates the engine speed by
sensing the engine's RPM with a magnetic pick-up at the
flywheel. The governor's controller continuously
monitors
the engines speed and if there is any discrepancy, the
controller signals the actuator and the actuator adjusts the
engine to the desired speed electronically.
Actuator
ENGINE MOUNTING
SURFACE
The following instructions are for adjusting or replacing
the actuator.
1. Shut-off the DC power to the generator.
2.
Disconnect the ac~or wires from the wiring harness.
3. Measure the distance between the actuator and the engine
mounting
surlace as shown.
ACTUATOR
MEASURE FOR
REFERENCE
ENGINE MOUNTING
. SURFACE
JAM NUT
'4. Back-offthe 1 7/1(:/' jam nut and unscrew the actuator.
S. Apply a small amount of teflon sealant to the replacement
actuator and
screw the actuator into the engine's
mounting boss.
Maintain the same distance between the
actuator and the engine mounting
surlace as previously
measured Secure the actuator's position with the jam nut.
(The standard distance
is 13/16' to 7/8'').
6. Reconnect the actuator wires and test the unit
SCREW IN TO
ORIGINAL MEASURE
K---13/16" TO 7/8"
STANDARD
NOTE: For additional infonnation and Electronic Governor
Troubleshooting, ,refer to your WESTERBEKE Service Manual.
Note: If unit fails to shut down at testing. Thread
actuator
in 1/8-1/4 tum until proper shut
down is achieved.
Engines & Generators
24