Operating instructions

OPERATING INSTRUCTIONS
REMOTE PANEL
Starting the Generator
To start the generator, hold the momentary ON switch in the
up
(on) position (the green light will come on), then hold the
momentary
START/STOP switch in the up (start) position
(both switches are held up together). After approximately one
second, the starter will engage and the engine will crank (the
green light will dim).
Once the engine is running (the green
light
will brighten», the stalter will disengage, and the
START/STOP switch may then be released to return to its
center
(run mode) position. Continue holding the ON switch
until the engine has sufficient oil pressure, then release it
to
its center position.
NOTE: Sfwuld the engine fail to start, release both switches,
wait
20 seconds, and try again. Never run the starter more
than
20 seconds at a time.
~~ __ OFF/RUN
STOP OFF
START/STOP SWITCH
Stopping the Generator
11-1.....::_-- OFF/RUN
ON SWITCH
To stop the generator, move the momentary START/STOP
switch to the down (stop) position then release it to the center
(off/run mode) position. This will de-energize the K2 run
relay
in the generator's control panel and stop the generator.
Engines &: Generators
8
REMOTE PANEL