Operator`s manual

5. Check the resistance of the glow plugs. (.4 to .6 ohms)
6. Check the sea water pump for internal wear. Examine the pump's cover, cam, and internal housing.
Replace worn parts as needed. Check for leaks and repair as needed.
NOTE: Items highlighted by an asterisk (*) should be performed by a competent mechanic.
Servicing
Aller Every 800 Hours 01 Operation
*1. Remove and check fuel injectors.
Injector spray pressure:
1991 psi + 140 psi
(140 kg/cm
2
+ 10 kglcm
2
)
Eliminate undesirable injection conditions including
aller dripping.
*2. Check the engine's compression pressure.
Remove each
glow plug and check each
cylinder's compression pressure. The engine's
cranking speed is at 280 rpm.
Standard Minimum
POOR
(i~~. f~~~: i'r. , ... 4
10104i
....... ' --~dI\
GOOD
455 psi
(32 kg/cm
2
)
369.7 psi
(26 kglcm
2
)
(Maximum difference between cyfinders: 35.5 psi (2.5 kg/cm
2
)
*3. Check the battery-charging alternator for proper operation.
*4. Check the tightness of
bolts, nuts, and clamps.
Servicing Aller Every 1000 Hours of Operation
1. Remove, clean, and pressure test the primary heat exchanger. (A local automotive radiator shop should
be able to clean and test the heat exchanger.)
NOTE: Operating in silty and/or tropical waters may require that a heat exchanger cleaning
be performed more often than every 1000 hours.
*2. Check the injection pump's timing.
Westerbeke
Diesel Engines
84