Operator`s manual

Servicing Alter Initial 50 Hours 01 Operation
1. Change the engine's lubrication oil and oil filter.
2. Replace the fuel filter element in the electric fuel lift pump and in the engine-mounted secondary fuel fil-
ter. Change the fuel filter element and clean the optional filter/water sediment or, H a separator has been
installed, and
il the model type permits cleaning.
*3. Torque the cylinder head bolts.
*4. Adjust valve clearances.
5. Adjust the alternator and water pump drive belt tension, if required.
6. Lubricate the throttle, the RUN linkage cable, and the transmission's remote control cable.
7. Change the transmission's oil.
8. Adjusts the engine's idle speed as needed.
9. Check to make sure the propeller shaft is securely connected to the transmission coupling.
Servicing Alter Every 100 Hours of Operation
1. Change the engine's lubrication oil and oil filter.
2. Adjust the alternator and water pump drive belt tension, if required.
3. Check the transmission fluid or oil level.
Servicing Alter Every 250 Hours of Operation
1. Replace the fuel filter elements in the electric fuel lift pump and in the engine-mounted secondary fuel
filter.
2. Change the transmission's oil.
Servicing Alter Every SOO Hours 01 Operation
*1. Torque the cylinder head bolts.
*2. Adjust the valve clearances.
3. Drain,
flush, and refill the fresh water cooling system. The illustration on pages 6 to 11 show the heat
exchanger and the zinc anode location. The drain plug
for the fresh water system is next to the zinc
anode.
*4. Check the condition of the starter motor drive pinion; lubricate the pinion.
83
Westerbeke Diesel Engines