Operator`s manual

BTD 7.6 KW POWER TAKE-OFF (PTO) ADAPTER
The generator housing
of the BID 7.6 KW is machined to accept the optional power take-off (PTO)
adapter kit #34786. This kit allows the user to mount and to operate a hydraulic pump (or similar device)
while the generator is operating.
The operator is advised that the generator's drive engine produces a specific horsepower at
1800 rpm
(continuous), 60 Hertz (8 HP at 1500, 50 Hertz). This horsepower can be utilized either for generator AC
output or to operate the PTO device. It cannot do both; that is, it cannot produce 7.6 KW of AC electrical
power and furnish horsepower
to the PTO device, simultaneously.
When mounting a
PTO device using the optional adapter kit #34786, ensure good alignment of the device
to the spline coupling and ensure that
if additional support is needed, it is added. When in doubt, provide
extra support.
o;;CNERATOR
HOUSINC
P.T.O. ADAPTER KIT
BPLXME COUPLXNC
AOAPTER
CAPSCRE;;W (3)
LOCK .... ACH£R (3)
I;:TUO (41
LOCKWAGHf;R (4)
"UT (4)
HYDRAULXC PUMP
HYDI'IE:CO
:t22l.8A4B1R
,"' __ ", ... TII_IlM_ (PUIroIP SOURCE)
HVDJlECO PUIoIPS
KALAMAZOO, HICH.
(6:16) 349-1511
NOTE: Provisions should be made to prevent the PTO device from overloading the generator's engine.
Install a pressure relief valve
On the hydraulic pump to limit maximum pumping pressure.
79
WESTERBEKE GENERA TORS