Operator`s manual
Rigging 
and 
Lifting 
The generator is fitted with lifting eyes.  Rope or chain slings capable 
of 
supporting the generator's weight 
should be attached to  the eyes  and the generator lifted by means 
of 
tackle attached to  these slings. 
Th 
lifting eyes have been designed to carry the full weight 
of 
the generator; therefore, auxiliary slings are not 
required or desired. 
II 
CAUTION 
II 
Slings must not be so short as to place significant stress on the generator's lifting eyes. 
Strain placed on the generator's lifting eyes by the lifting sling must not be in excess 
of 
10° from the vertical pain. 
ENGINE 
SLING  LIFTING 
ANGLE 
SHOULD 
BE 
AS 
SMALL 
AS 
PDSSIBLE 
LIFTING 
EYE 
The general rule in moving generators is to see that all equipment used is amply strong and firmly fixed 
in place.  Move the engine a little at a time 
and 
see that it is firmly supported.  Eliminate the possibility 
of 
accidents by avoiding haste.  Do not lift the generator by its crankshaft position.  Certain situations exist 
by which the engine must be  lowered endwise through a  small hatchway which cannot be made larger. 
Under these conditions, 
if 
the 
opeuingofthe 
hatchway is extremely small, it is possible to reduce, to some 
e,,"(ent, 
the outside dimensions 
of 
the  generator by  removing  external  components  such  as the cooling 
system's  accessory  equipment should be  removed 
by 
a  competent mechanic 
and 
special care  should be 
taken to  avoid damage to any exposed parts. 
In addition, be careful  not 
to 
allow dirt from entering any 
opeuing created 
by 
the removal 
of 
equipment.  Removed  parts  should  be  returned  to their  respective 
position once the generator is in its installation area.  Replace gaskets as needed for the parts that were 
removed. 
In  case  it  becomes  necessary  to hoist  the  generator front-end upwards 
or 
generator-end upwards,  the 
attachment 
of 
lifting slings must be done  carefully 
to 
avoid  the  possibility 
of 
damaging the  parts  on 
which the weight 
of 
the slings may bear.  Special rigging work is best done by someone experienced and 
competent in handling heavy machinery. 
WESTERBEKE 
GENERATORS 
14 










