Operator`s manual
INSTALLATION CHECKS 
General 
Because the crafts in which Westerbeke  engines and generators are installed vary in design,  installation 
procedures will vary according to your craft's specific design.  It is not the  intent of this section 
to 
advise 
boatyards  or installers on procedures  already  well-developed  and  well-understood.  However,  it  is 
important  that  the owner/operator realize there  are details 
of 
the  installation  which  require periodic 
checks to ensure the best  operating conditions  for  the  equipment  and safe  operating conditions 
for 
the 
personnel  on board.  Proper  location  and  installation  of the generator set  in  the  vessel  are of prime 
importance. 
Factors  in  the  installation  that 
must 
be 
considered  are  ventilation, 
so 
as  to  cool  the generator  and to 
provide air for  engine combustion; exhaust system,  to  properly discharge raw cooling water, to  quiet the 
exhaust and to expel the exhaust gas;  cooling water supply; the electrical  connections, both AC  and DC, 
and a 
fuel 
system that will provide an unrestricted fuel  supply and properly filtered fuel 
to 
the fuel pump 
on the engine. 
II 
CAUTION 
II 
For safety reasons,  the generator's engine is not filled with lubricating oil for shipment. 
Before leaving the factory, however,  each generator set 
is 
thoroughly tested with oil  in 
its engine.  This testing, among other things, provides all internal parts with a coating of 
oil.  This oil acts as a  preservative, providing reliable protection against corrosion for at 
least one year 
if 
the generator 
is 
properly stored. 
Inspection of Equipment 
The generator is shipped from the factory securely mounted and properly crated.  Accessory equipment is 
shipped in a separate small box, usually packed within the generator's crate. 
Before  accepting shipment  of the generator  set from  the transportation  company,  the crate  should  be 
opened and the contents inspected for  concealed damage. 
If 
either visible or concealed damage is noted, 
you  should require the  delivery agent sign 
"Received  in  damaged condition"  on  the  proper  delivery 
receipt.  Also,  check the contents of the shipment against the packing list and make sure that the proper 
notation is 
made 
if 
any 
discrepancies exist.  These 
noted 
discrepancies 
are 
your 
protection 
against loss 
or 
damage.  Claims concerning loss or damage must be made 
to 
the carrier, not to Westerbeke Corporation. 
13 
WESTERBEKE 
GENERATORS 










