Technical data

5. Disassembling Cautions
When disassembling, keep in mind the following cautions. Note that the order of disassembly and
reassembly will vary with change of specifications.
1. Before disassembly and cleaning, carefully check for defects which cannot be found after
disassembly and cleaning.
2. Before disassembly, drain all drain water, oil and fuel. Check dirtiness of the oil.
3. Clean or wash the engine exterior.
4. Do not disassemble or remove the parts that require no disassembly.
5. Perform disassembly in a proper order using proper tools. Arrange the disassembled parts in
good order. Apply oil when necessary. Take special care to keep parts of the fuel system from
dust.
6. Reassembly Cautions
1. Service all parts needed for reassembly.
2. Clean or wash the parts, and apply oil where specified.
3. Carefully check gaskets, packings and oil seals even if not specified to check. Replace with new
ones if defective.
4. Be sure to install in proper directions and positions (see dowel pins, mating marks and specified
directions). When tightening torque is not specified, tighten evenly to an ordinary torque. Apply
a sealant where specified.
5. After completion of reassembly, re-check for abnormality. Prepare for starting the engine. Run
the engine idle sufficiently for test run.