Technical data

4. Glow Plug
'When the positive cable of the battery is connected to the glow plug
terminal and the negative cable of the body, the glow plug must glow
red hot.
Reassembly
1. Starter
CAUTION:
PRIOR TO INSTALLATION, CLEAN THE STARTER FLANGE AND CRANKCASE
MOUNTING SURFACE THOROUGHLY BY REMOVING ALL OIL, PAINT AND RUST.
THE STARTER PERFORMANCE LARGELY DEPENDS ON THE QUALITY OF WIRING. USE
WIRE OF SUFFICIENT SIZE AND GRADE BETWEEN THE BATTERY AND THE STARTER
AND FULLY TIGHTEN EACH TERMINAL.
2. Alternator
CAUTION:
CONNECT THE ALTERNATOR AND BATTERY PROPERLY. SHOULD THE BATTERY
POLARITY BE REVERSED, A TREMENDOUS CURRENT WOULD FLOW FROM THE
BATTERY INTO THE ALTERNATOR, DAMAGING THE DIODES AND WIRING HARNESS.
a. Align hole in the alternator leg with hole in gear case and insert the alternator support bolt
from the front bracket side.
b. Install the adjusting strap.
c. Install the belt.
d. Push the alternator toward the rear of the engine and check clearance between alternator leg
and gear case. If the clearance is more than 0.2 mm (.008 in.), insert spacers, 0.198 mm
(.0078 in.) thick, as required.
e. Remove alternator support bolt, insert the spacers as selected in step (d), reinsert the bolt and
tighten the nut.
f. Adjust the belt tension.
g. Tighten the alternator support bolt nut and adjusting strap to the specified torque.
Alternator support bolt nut 20 - 24 Nm
(15 - 18 ft-lbs.)
Adjusting strap bolt 12 - 14 Nm
(9 - 10 ft-lbs.)