Technical data

The position of the cover plate underneath the actuating lever is factory-adjusted to ensure equal lever
travel from neutral position to A and B. Therefore, do not loosen the capscrews mounting this assembly.
When installing the gearbox, make certain that shifting is not impeded e.g. by restricted movability of
the cable or rod linkage, by unsuitably positioned guide sheaves, too small bending radius, etc.
7. ENGINE-GEARBOX COMPARTMENT
Care should be taken that, the engine-gearbox compartment is properly ventilated.
OPERATION
1. INITIAL OPERATION
Fill the gearbox with automatic transmission fluid. The oil level should be the index mark on the
dipstick (see illustration).
To check the oil level, just insert the dipstick; DO NOT SCREW IN. Retighten the hex screw with the
dipstick after the oil level check. Do not omit the o-ring seal.