Technical data

5. SHAFT BEARINGS
Both the input and the output shafts are carried in amply dimensioned taper roll bearings.
The intermediate gear and the movable gears are carried in sturdy needle roller bearings.
6. SHAFT SEALS
External sealing of the input and output shafts is provided by radial sealing rings. The running surface
on the shafts is casehardened.
7. LUBRICATION
The transmissions are immersion-lubricated. The bearings are generously supplied with splash oil and oil
mist.
INSTALLATION
1. DELIVERY CONDITION
For safety reasons, the gearbox is NOT filled with oil for shipment. The actuating lever is mounted on
the actuating shaft.
Before leaving the factory, each transmission is subjected to a test run with the prescribed ATF oil. The
residual oil remaining in the transmission after draining acts as a preservative and provides reliable protection
against corrosion for at least 1 year if the units are properly stored.