Operator`s manual
5. Adjust the alternator and water pump drive belt tension,
if
required.
6.
Adjust the engine's no-load speed,
if
required (Hertz). Please note that this adjustment is not a warrantable
adjustment during
or
after the unit's break-in.
Servicing After Every 100 Hours
of
Operation
1.
Change the engine's lube oil and oil filter.
2.
Adjust the alternator and water pump drive belt tension,
if
required.
3. Check siphon break operation (when installed).
Servicing After Every 250 Hours
of
Operation
Replace the fuel filter elements in the electric fuel lift pump and in the engine-mounted filter assembly.
Servicing After Every 500 Hours
of
Operation
*1. Torque the cylinder head hold down bolts.
*2. Adjust the valve clearances.
3. Drain, flush, and refill the fresh water cooling system.
*4. Check the condition
of
the starter motor drive pinion; lubricate pinion.
5. Check for proper operation
of
preheat circuit and glow plugs.
*6. Check the generator for proper operation. Also check the generator's
AC
output connections for security make
sure that these connections are not chafing.
7.
Check the outside
of
the engine. Make sure that any oil on the engine's surface is cleaned.
Any
dirt
or
oil on the
engine inhibits the engine's ability
to
remain cooL Please keep th engine clean.
8.
Check the condition
of
the DC battery charging alternator making sure that all the connections are clean and
secure
and that the alternator's voltage output is correct.
9. Check the condition
of
the sea water pump making sure that the pump's impeller is serviceable. Check the
internal wear
of
the pump, and replace worn components as needed.
10. Check water injected exhaust elbow for carbon andlor corrosion build-up
on
inside passages. Clean/replace as
needed.
11. Inspect sea water pump drive. Remove the pump and check drive tank and pump shaft. Replace as needed.
49