Installation manual

EMISSIONS
This genset meets the requirements of California's Exhaust
Emissions Standards as stated on the nameplate.
You should carefully review operator (Owner) Installation
and other manuals and information you receive with your
genset. If you are unsure that the installation, use, .
maintenance or service of your genset is authorized, you
should seek assistance from an approved WES1ERBEKE
dealer.
California users of this genset should be aware that
unauthorized modifications or replacement of fuel, exhaust,
air intake, or speed control system components that affect
engine emissions are prohibited. Unauthorized modification,
removal or replacement of the engine label is prohibited.
California genset users may use the table below as an aid in
locating information related to the California Air Resources
Board requirements for emissions control.
Federal Emissions Compliance Period: The Federal
Emissions Compliance Period referred to on the nameplate
indicates the number of operating hours for which the engine
has been shown to meet Federal Emissions requirements.
Catagory C= 250 hrs, B=500 hrs,m A =lOOO.hrs.
EMISSIONS CONTROL INFORMATION TABLE
The California emissions control wartanty statement is located in the same
Emissions Warranty Information
packet, if information as this manual when the genset is shipped from the
factory.
Engine Fuel Requirements
The engine is certified to operate on unleaded gasoline. See FUEL
RECOMMENDATIONS.
Engine Valve Adjustment See MAINTENANCE SCHEDULE.
Engine Ignition Timing See MAINTENANCE SCHEDULE.
Eligine Lubricating Oil Requirements See ENGINE OIL RECOMMENDATIONS.
Engine Adjustments ECU.
Engine Emission Contol System
The engine emission control system consists of engine design and precision
manufacture.
Catalyst See MAINTENANCE SCHEDULE.
Oxygt:n Sensor
See MAINTENANCE SCHEDULE.
Back Pressure See MAINTENANCE SCHEDULE.
55